The Mad Scrapper Blog

Hi everyone, Nicola here sharing my first layout using the September 2026 Scrapaholix Kits, which are based around Uniquely Creative's Oh So Lovely collection. The blog post walking you through the contents of both the main and add-on kits can...

Hi everyone, Nicola here sharing my first layout using the June 2026 Scrapaholix Kits, which are based around the Memoir range from Maja Design. The blog post walking you through the contents of both the main and add-on kits can...

First I used a piece of my own Bazzill Avalanche card stock as the base and cut several strips of the patterned paper. I cut some at 2” and several at 1.5” and cut them to 8” or 9” long. I...

Hi everyone, Nicola here sharing my first layout from the March 2026 Scrapaholix Kits, which are based around Graphic 45's Journaling Through Time collection. The blog post walking you through the contents of both the main and add-on kits can...

Hi everyone, Nicola here sharing my next layout from the November 2025 Scrapaholix Kits, which are based around Bella Blvd's Documented collection. I started with the Currently Loving sheet, which comes in the main kit - if you saw my...

Hi everyone, Nicola here sharing my first layout from the November 2025 Scrapaholix Kits, which are based around Bella Blvd's Documented collection. I started with the Currently Loving sheet, which comes in the main kit, and cut a circle out...

Take the Lush patterned paper and cut it in half. Then cut a 7” piece of the Whirlpool card and stick the two together overlapping by 1” Cut a 6” hexagon and a 5.5” hexagon from the Fresh paper. You...

I started with a sheet of white cardstock (you get 2 in the Sep kit; as I've already used both of those on my previous layouts, I used one from the white cardstock pack linked below) and created some splatters...

First I cut a large star from the Fabulous Floral paper and used the reverse green side. My remaining paper from the first layout I created  wasn’t quite big enough to cut the entire star but the missing point wasn’t going to show so...